This ultra low profile Power Supply delivers 12 Volts with 29 Amps. This is the ideal Power Supply for most electronic setups.
"This Power Supply will super heat a 3D printer's extruder and heated bed swiftly with plenty of power to spare!"
- Qty. 1
- 215mm(~8.50") x 115mm(~4.5") x 30mm(~1.25")
- Voltage select switch 110V - 220V
- 2 DC Outputs
- Built-in Cooling Fan
- 85% Efficiency
- UL 60950-1 Approved
The fan is temperature controlled. It only turns on when the PSU internals heat up above 50degC and then turns back off once the internals fall below 40degC again.
Warning - Be sure to disconnect power before attempting to to switch voltage. Power Supply should always be unplugged while you make the connections and also make sure the shield is in place before plugging the cord into an outlet. Warning - high voltage! Always have a qualified electrician connect this unit. Use at your own risk!
OpenBuilds Part CAD Models and Drawings